Conrad C-Control Pro Mega Series, Руководство пользователя

Страница: 73 / 240

64 IDE
© 2008 Conrad Electronic
4.3.1 Start Program
Program Transfer
After a project has been translated free of errors the Bytecode must first be transferred onto Mega32
or Mega 128 before it can be executed. This is done by use of the command
Transfer (Shift-F9) in
menu C-Control .
Not only the Bytecode is transferred to the Mega Module. At the same time the latest interpreter
version is sent to the C-Control Module.
Start
By Start (F10) the execution of the Bytecode is brought about on Mega 32 or Mega128.
Stop
During normal operation a program will be stopped by pressing the RESET1 button. For performance
reasons the program execution on the Module is during normal operation not being stopped by use
of software. This can however be performed with the IDE function
Stop Program when the program
runs in Debug Mode.
In rare cases the system can get jammed during USB operation when the RESET1 button is
pressed. To overcome this please also press RESET2 in order to issue a Reset pulse to the Mega8,
too. The Mega8 is on the Application Board responsible for the USB interface.
Auto Start
If no USB interface is connected and SW1 has not been pressed during power-up in order to reach
the
Serial Bootloader Mode the Bytecode (if available) is started in the Interpreter. I.e. if the Module
is built into any hardware application the mere connection of the operating voltage is sufficient to
automatically start the user program.
A signal on INT_0 during switch-on of the C-Control Pro Module can interfere with the auto start
behaviour. According to the pin assignments of M32 and M128 INT_0 is connected to the same pin
as switch SW1. When SW1 is pressed during power-up of the Module this will activate the Serial
Bootloader Mode and the program will not automatically be started.