5
INSTRUCTION MANUAL
Please read and retain these instructions for future reference.
CP203
2
3
4
HIGHLIGHTS
ADJUST LIMIT SWITCH
ELECTRIC SCREEN
PACKAGE CONTENTS
SPECIFICATIONS
Adjust position for the two limits, refer to below picture:
• Plug in the power supply. Press the down button, the screen will
go down smoothly. Press the stop button when the screen goes
down to the expected position, otherwise the screen will stop at
the lower limited position automatically.
• The screen should be plugged to a suitable power supply. It can be
220 v / 50 hz, 230 v / 50 hz, or 110 v / 60 hz, 120 v / 60 hz.
• Unpack the screen carefully,be sure the screen is in good
condition, check all the accessories are packed inside the carton.
• It is suggested only to use the screens indoor under normal
temperature and humidity.
• Refer to the below fig and fix the screen to the wall or to the
ceiling.
• 100” Screen Size
• Electronic Motor
• Wired Remote Control
• Matt White Fabric
• Connex E-Luminate Electric Projector screen with Remote
100” - 16:9
• Instruction Manual
• 64 Octagonal Housing Case
• Matt White Fabric
• Fabric Thickness: 0.4mm
• Electronic Motor: 220-240v AC
• Wired Remote Control
• Black Framed screen
• Screen Size: 2214 x 1245 mm (Open)
Fix the screen to the wall.
Fix the screen to the ceiling.
E-LUMIN
ATE
Electric Projector Screen
TM
Motorized Screen with Manual Switch.
Mounting Ring
Screen
Housing
Manual Switch
Black Border
Bottom Bar
• Press the up button, the screen will go up smoothly. Press the stop
button when the screen goes up to the expected position,
otherwise the screen will roll back to the housing.
• Moving parts of the drive must be installed higher than 2.5 m
above the floor or other level that could provide access to it.
HOW TO USE
