background image

SAND

Note:  40 lbs.
of sand
required!

(See Step 8)

SAVE THESE INSTRUCTIONS

DEALER/INSTALLER: GIVE TO HOMEOWNER

CONFER-STEP-1

Above-Ground Pool Steps

ASSEMBLY AND INSTALLATION MANUAL

Made in the U.S.A. by

www.conferladders.com

Содержание STEP-1

Страница 1: ...e 40 lbs of sand required See Step 8 SAVE THESE INSTRUCTIONS DEALER INSTALLER GIVE TO HOMEOWNER CONFER STEP 1 Above Ground Pool Steps ASSEMBLY AND INSTALLATION MANUAL Made in the U S A by www conferladders com ...

Страница 2: ...two long posts and two short posts as required in step 7 Secure each step by fully inserting the locking wedges saved from step 1 between the side panel and the top surface of both ends of each step Step 1 Step 3 Step 5 Step 6 Step 4 Lay one of the side panels down on a clean flat surface Push the end of each step into the openings of the side panel Make sure that the riser groove in the top of ea...

Страница 3: ...y the plain ends of all four handrail posts with liquid soap or spray lubricant Top End accepts the ends of handrails Plain End coat outside of end with liquid soap or spray lubricant Step 8 Step 9 Step 11 Step 10 Side 8a IMPORTANT To prevent floating you MUST do the following Pour about 10 pounds of dry sand into each of the four openings indicated above Shake unit to distribute the sand evenly A...

Страница 4: ...nd tilting the unit to drain some of the water from the steps After the unit is light enough carefully lift it from the pool Caution Use care when lifting the unit It will weigh at least 130 lbs If you have the Confer Step Enclosure System or Connector System disconnect the two units by removing the center platform side rail assembly at the top of the steps Do not stand on the top step of the outs...

Отзывы: