Conergy IPG 11 T, Руководство по эксплуатации

Страница: 69 / 384

6 Operating manual Conergy IPG T series
2 Safety
ENGLI
S
H
DO_BA_2
0
0
9
_1
24_1
E
NG_BCo
15
.2.
1
0
| The correct country-specific parameter set is selected from
the display;
| The product is used only in the countries intended
(Belgium, Germany, France, Greece, Spain, Portugal, Italy,
Czech Republic, Slovakia, Bulgaria, Poland, Austria,
Switzerland, Luxembourg and the Netherlands);
| Packaging material is disposed of in an environmentally
friendly manner.
2.2 Basic safety instructions
Before starting any work on photovoltaic systems, note the
following safety rules:
| Disconnect the unit.
| Ensure that the unit cannot be switched on again.
| Verify that the system is fully deenergised.
| Earth and short-circuit the unit.
| Cover adjacent live parts.
| First connect the power cable and then the solar power
system wiring, since PE is connected with the power cable.
| A second person must be present.
In the event of an unforeseen electrical accident, that
person must be able to switch off the power supply and
provide assistance.
| There are high DC voltages present. These may cause
arcing if a malfunction occurs or if plugs or safety devices
are improperly used.
| The connected power source is permanently enabled .
Depending on the operating status, voltage from the solar
power system may be supplied to the inverter. This must be
noted in particular when disconnecting from the mains.
| The inverter cooling element and choke can reach a
temperature of up to 100 °C when in operation.