Conel CLEAR 2.0 SAFE, Руководство по эксплуатации

Страница: 29 / 76

29
2
SYMBOLS AND UNITS USED
The safety instructions contained in these operating instructions are labelled with the following symbols:
Instructions attached directly to the control sensor, such as
/ Direction of flow (see fig. 1),
/ Type label,
/ Cleaning information,
must be observed without fail and maintained so that they are always legible.
The following units and terms which do not form part of the SI (Système International d’Unités) system are
used:
Attention!
This symbol refers to a point which must be observed to ensure reliable operation and safety.
Note!
This symbol highlights user tips and other useful information.
Warning!
This symbol flags up an electrical voltage warning.
Unit:
This symbol indicates torques specified by the manufacturer.
Fig. 1: Rotary flange fitting
Unit Conversion
bar
1 bar = 10
5
Pa = 0.1 N/mm
2
¾" DN 20
1" DN 25
1¼" DN 32