Operation Manual
Regulator
4 kW 560 V DC 40% Duty Cycle + 24 V DC
BAL9100-0126d-EN
www.conductix.com
original document
page 30 of 32
14.3
Interface
A 5 meter long cable, preassembled with one male connector on one side, can be ordered
separately through Conductix-Wampfler under material number:
91212-339-3047358
A compact enable plug allowing an automatic start-up of a Regulator is also available for
order through Conductix-Wampfler under material number:
91000-400-3089971
Note: this plug does not allow any remote ON/OFF function nor any of the diagnoses
possibilities. Refer to the product documentation for more information.
Otherwise you can find in the table below a choice of possible solutions for the connection to the interface:
Description
Material number
Phoenix Contact
Material number
Binder
5 m shielded cable,
preassembled with 1 male connector
1543113
79 3579 3508
5 m unshielded cable,
preassembled with 1 male connector
--
79 3479 3508
Male connector,
preassembled with wires
1523492
09 3481 700 08
Male connector,
with solder terminals only
1542758
--
The information below is for reference only. It relies on the 2007 specifications of the manufacturers for
the material mentioned in this paragraph only. In case of any doubt, or when using different material than
those mentioned above, it will be necessary to check the correspondence between the pin number and
the color of each wire in order to avoid possible damage to connected devices.
PIN 1
> white
PIN 2
> brown
PIN 3
> green
PIN 4
> yellow
PIN 5
> grey
PIN 6
> pink
PIN 7
> blue
PIN 8
> red or shield