Operation Manual
Regulator
4 kW 560 V DC 40% Duty Cycle + 24 V DC
BAL9100-0126d-EN
www.conductix.com
original document
page 17 of 32
7.5.3
Proximity to Iron/Steel
There are no special requirements regarding the proximity of the Regulator itself to ferromagnetic material. However special care
should be taken regarding the presence of ferromagnetic material near the Pickup (refer to chapter 14.1 for more information) and
near the IPT
®
track itself (Refer to the entire documentations related to the installation of your IPT
®
system).
We strongly recommend to respect the specifications for areas free of ferromagnetic material as specified in the document
mentioned above, and even to go beyond these requirements whenever possible.
7.5.4
Attachment Points
Attaching a Regulator to a supporting structure must be done without opening the lid. For that purpose, four holes are accessible
from the top of the device.
Warranty seals are placed on the housing in order to forbid the opening of the lid and therefore preventing accidental soiling or
insertion of foreign parts. Breaking a seal will terminate the warranty.