Condair RH 1.8, Инструкция по установке и эксплуатации

Страница: 50 / 68

50 Maintenance
7.4.1.2 Installation of the steam cylinder
1. Make sure that the seal on the steam connection of the steam cylinder is attached and not damaged.
2. Insert the steam cylinder into the receptacle in the unit at an angle from above.
3. Push the lever down as far as it will go.
4. Close the unit door.
2 3 4
5. Connect the Condair RH to the power supply (RH 1.8: plug in the mains cable, RH 3.6: Switch on
electrical isolator) and open the filter valve or shut-off valve in the water supply line.
6. Switch on the Condair RH via the On/Off switch on the unit.
Note: The control of the Condair RH automatically recognizes that a new steam cylinder has been
inserted and automatically resets the maintenance counter.
Note: If the fault LED lights up yellow or red after replacing the steam cylinder, press the On/Off switch
on the unit for approx. 3 seconds to reset the fault indication. If a fault shows up again, the steam cyl-
inder may be defective.
Note: If the conductivity of the water is low, it is possible in the first hours of operation that the required
steam output will not be achieved. This is normal. As soon as sufficient conductivity of the water is
achieved through the evaporation process, the steam humidifier will work with the required output.