Condair Control GS OC-C Series, Руководство по эксплуатации, Страница: 25 / 40

5
Service Relay
Off 12.00.00
Error Relay
Off
4.1.5.10 Configuring float check function
With this functions you can activate and deactivate the float check function and if activated specify
the hour of the day at which a float check takes place. Float checks are important to ensure the water
level detection system is operating correctly. The float check also tests the fill and drain system and
will report any problems detected.
Select “ Float Check ” in the water management menu, then press the <Set> key.
In the upcoming float check submenu select "Status" to activate or deactivate the float check function
or select "Time" to set the hours of day at which the float check should be started (format: hh:mm).
Select “ Remote Test ” in the settings menu, then press the <Set> key.
The list with the remote relay tests appears. Press the < > and < > keys in order to select the de-
sired relay test and press the <Set> key to activate/deactivate the corresponding relay for testing.
When switching on a relay, the respective front panel LED lights up.
4.1.6 Performing remote relay tests
With the test functions under “ Remote Test ” you can check the function of the relays “Steam”,
“Service” and “Error”.
Settings
Water Mngm. :Set
Remote Test :Set
Date :01.10.08
Power Limit :100
Time :12:12
Unit Steam :kg/hr
Esc Set
Remote Test
Steam Relay
Off
Esc Set
Settings
Power Limit :100
Water Mngm. :Set
Remote Test :Set
Controls :Set
Date :01.10.08
Time :12:12
Esc Set
Water Management
Idle Mode :Set
Idle Drain :72
Fill Corr :100
FTBD :Off
Drain Corr :100
Float Check :23:30
Esc Set Esc Set
Float Check
Time :23:30
Status :On
Esc Set
Status
On
Off
On
Float Check
Time :23:30
Status :On
Esc Set Esc Set
Time
23:30
23 :30