Concoa 529 5134-01-120 Скачать руководство пользователя страница 1

Protocol Station

Remote Alarm

529 5134-01-120
529 5134-01-230

INSTALLATION

AND OPERATION

INSTRUCTIONS

Before Installing or Operating, Read and Comply with These Instructions

Controls Corporation of America

1501 Harpers Road • Virginia Beach, VA 23454

To Order Call 1-800-225-0473 or 757-422-8330 • Fax 757-422-3125

www.concoa.com

October 2002

Supersedes October 2001

ADI  3192-D

Certified ISO 9001

For use in

Non-Hazardous Locations

Controls Corporation of America

1501 Harpers Road • Virginia Beach, VA 23454

To Order Call 1-800-225-0473 or 757-422-8330 • Fax 757-422-3125

www.concoa.com

ADI  3192-D

Certified ISO 9001

Содержание 529 5134-01-120

Страница 1: ...ca 1501 Harpers Road Virginia Beach VA 23454 To Order Call 1 800 225 0473 or 757 422 8330 Fax 757 422 3125 www concoa com October 2002 Supersedes October 2001 ADI 3192 D Certified ISO 9001 For use in Non Hazardous Locations Controls Corporation of America 1501 Harpers Road Virginia Beach VA 23454 To Order Call 1 800 225 0473 or 757 422 8330 Fax 757 422 3125 www concoa com ADI 3192 D Certified ISO ...

Страница 2: ... or altered by anyone other than CONTROLS CORPORATION OF AMERICA or if the equipment has been subject to abuse misuse negligence or accident CONTROLS CORPORATION OF AMERICA s sole and exclusive obligation and Buyer s sole and exclusive remedy under the above warranties is limited to repairing or replacing free of charge at CONTROLS CORPORATION OF AMERICA s option the equipment or part which is rep...

Страница 3: ...ocol Station equipped with pressure switch gauge two connector assemblies 830 9170 22 as shown in Figure 1 soldering iron solder 4 wire cable Use wire that can be inserted into the pins of the connector assembly 22 gauge wire is recom mended For the alarm cable connection to be water resistant a cable with outside diameter 195 265 must be used 1 Locate the two connector assemblies Slide all of the...

Страница 4: ...uring normal operation should be necessary If adjustment of the alarm set point is required slide the red tab seen on the inlet gauge to the desired alarm point see figure 2 If the green remote alarm LED s do not illuminate when the transformer is plugged in and the remote alarm is not connected to the switchover check the fuse Disconnect the transformer from the power source Remove the four screw...

Отзывы: