Concept2 SDV 2330, Руководство пользователя, Страница: 49 / 56

47 SDV3360
EN
• The manufacturer bears no responsibility for damage caused to people or objects as a result of a missing or bad
protective connection.
• The power cord must be located so that it does not come into contact with hot parts of the unit and so that it is
not deformed and excessively bent.
Connection of the terminal box of the unit
WARNING!
Only authorized personnel can install the connection!
A switch or circuit breaker for disconnection of the unit from the mains must be installed in the wiring before the unit,
where the distance between open contacts of all poles is at least 3 mm.
The unit
must
be connected:
By a 3-core supply cable (230 V)
Use a cable with wires of a diameter of at least 4 mm, e.g. the H05V2V2-F3x4.0 type, and press endings on its ends to
prevent fraying. For the connection see Fig. 3.
After fixation of the ends of the wires under the heads of the screws in the terminal box insert the cable in the
terminal box and secure it with a clip against pulling out.
After the connection turn the unit into the working position, put it in the cut-out and check the position of the supply
cable.
230 V ~, H05V2V2-F3x4,0 Fig. 3
TROUBLESHOOTING
Problem Cause, solution
The household wiring protection
reacts to the switching on of the
heating plate. Check that the input of all switched-on units does not exceed the maximum load of
the household wiring. Check whether the protection breaks in case of switching on
of another hotzone too.
The heating plate has switched
off. Somebody has touched the main switch accidentally. Switch on the heating plate
again. Perform setting once more.
When you put a utensil on
a hotzone, its display starts
blinking (and the hotzone does
not heat). If the cooking utensil has got too hot during use, let it cool down.
If the indicator does not shine even after the next switching off and on again,
disconnect the heating plate from the mains. Wait 20 seconds and then connect it
again.
EN
49 SDV 2330