Concept2 SDV 2330, Руководство пользователя, Страница: 48 / 56

46 SDV3360
EN
6. Before installing the unit in the cut-out in the worktop, stick sealing against the leakage of liquids along the
perimeter of the bottom part of the glass-ceramic plate (enclosed depending on the type).
7. Position the unit onto the edge of the board and pass the power cord through the opening so that the plug or
terminals remain accessible after installation.
8. Push the unit carefully into place. Be careful not to squeeze the power cord. Fix it in the required position using 4
clamps (supplied).
9. Plug the supply cable in the wall outlet or the terminal box.
Removal
To uninstall the unit, it is important to proceed correctly:
1. First, unplug the power cord from the mains (pull out the plug or switch off the circuit breaker).
2. Remove the attachment screws.
3. Slide out the unit and at the same time pull out the power cord carefully.
Connection in the mains
• Only a qualified expert can perform connection of the unit.
• Make sure the mains voltage and current protection correspond to the values on the rating plate. Otherwise
the installed electric circuit could be overloaded, especially in the case of single-phase connection (230 V). We
recommend using a separately protected electric circuit.
•
Use earthed wall outlets only.
• Do not use adapter plugs, connectors or extension cables. They could create a risk of fire due to overheating.
• The supply cable plug or the circuit breaker has to be freely accessible even after the installation of the unit.
•
The electrical safety of the unit can only be guaranteed if the protective terminal of the unit is connected to the
protective conductor of the mains.
Fig. 2
EN
48 SDV 2330