Concept2 SDV 2330, Руководство пользователя, Страница: 47 / 56

EN
45 SDV3360
UNIT INSTALLATION
• Only the customer is responsible for installation in situ. Defects caused by incorrect installation are not covered by the
warranty.
• The manufacturer bears no responsibility for damage caused to people, animals or objects as a result of incorrect
installation.
• To ensure the correct function of the unit, place it in suitable furniture.
• The unit should be installed in standardised kitchen furniture designed for built-in appliances or in properly adapted
furniture of dimensions according to Fig. 1 and 2.
• The kitchen furniture must be made of sufficiently heat-resistant material. The materials and adhesives used must be
resistant to heating of the unit according to standard ČSN EN 60335-2-6. Materials and adhesives that do not meet
the stated standard may deform or loosen.
When installing the unit, follow these instructions:
1. Remove all the covering and marketing materials from the unit before the first use. Install the heating plate in
a cut-out in the worktop of a minimum thickness of 30 mm, with the surface covered with a heat-resistant material.
The worktop must be installed horizontally and at the wall it must be sealed against leaking liquids. Ovens, the
combustion products of which could flow up under the heating plate, cannot be installed under the heating plate
without taking special measures.
2. The required dimensions of the built-in hole in the worktop are on Fig. 1. Leave min. 50 mm space for the adjacent
cabinets on the sides. Leave at least 50 mm free space behind the heating plate.
Fig. 1
3. We recommend installing a vapour absorber above the heating plate; a top box can be located above it. The minimum
distance of the vapour absorber above the heating plate is 600 mm. Install a separate box without the vapour absorber
min. 760 mm above the heating plate.
4. For installation use a worktop with a minimum thickness of 30 mm.
5. For the sake of efficient air circulation the unit has to be located according to the dimensions on the Fig. 2 and the
design of the cabinet must enable air flow into its bottom part. A gap of at least 20 mm shall be below the heating
plate and at least 50 mm behind the rear wall of the box.
A
268 + 4-0 mm
B
500 + 4-0 mm
C 50 mm mini
D 50 mm mini
E 50 mm mini
F 50 mm mini
EN
47 SDV 2330