63
EN
IDV2060, 5460, 5560
400 V 2N ~, H05V2V2-F4x4,0
Fig. 6a
400 V 2N ~, H05V2V2-F4x4,0
Fig. 6b
After fixation of the ends of the wires under the heads of the screws in the terminal box insert the cable in the
terminal box and secure it by clip against pulling out.
After the connection turn the unit into the working position, put it in the cut-out and check the position of the
supply cable.
Operation sounds of the unit
The induction heating technology is based on specific parameters of metal materials, when under the influence of high-
frequency waves. Under special circumstances these vibrations can manifest themselves by weak sounds, which do not
signal any fault. These include:
TROUBLESHOOTING
Problem
Cause, solution
The household wiring protection
reacts to the switch-on of the
heating plate.
Check whether the input of all switched-on units does not exceed the maximum load
of the household wiring. Check whether the protection breaks in case of switching on
of another hotzone too.
The display of all hotzones blinks, a
sound signal is heard.
The control panel is very dirty, some food has overboiled on it or a thing is lying on
the control panel. Clean the control panel thoroughly.
The heating plate has switched off.
Somebody has touched the main switch accidentally. Switch on the heating plate
again. Perform setting once more.
When you put a utensil on an
induction hotzone, its display starts
blinking (and the hotzone does
not heat).
Check whether the cooking utensil is electromagnetic (i.e. whether it attracts a
magnet). Check whether the bottom diameter of the utensil is sufficient.
If the cooking utensil has got too hot during use, let it cool down.
If the indicator does not shine even after the next switching off and on again,
disconnect the heating plate from the mains. Wait 20 seconds and then connect it
again.
The Powerboost function indicator
blinks and goes off.
During the Powerboost function the hotzone is heating with the highest possible
power. After a longer time of cooking it is possible that the hotzone switches off this
function automatically, to protect the heating plate against overheating. As soon as
the indicator stops blinking, you can start using the hotzone again.