AHD CAMERA QUICK START GUIDE
Packaging Contents
Technical Documents
4-in-1 AHD Camera x1
Silica Gel x1
Quick Start Guide x1
Fitting Screws x3
Mounting Template x1
Screw Anchors x3
DC12V/AC24V Power Input Cable x1
2. INSTALLATION
Important: Ensure all precautionary procedures are observed during installation.
It is recommended that the camera is tested in low light and harsh lighting conditions during
installation to ensure continuity of effective CCTV monitoring.
Open Packaging
Open packaging, remove camera, and set aside the included accessories.
Drill Mounting Holes
Attach the included mounting template to the desired
mounting surface (ceiling or wall). Ensure the surface can bear
the camera weight. Drill mounting holes and cable throughput
holes according to the template. Insert the included screw
anchors into the holes. Grip the side of the dome cover and
rotate to unlock and remove the dome cover. Note: the dome
cover is connected to the dome base with a safety leash.
Mount the Camera
Insert any required cables through the cable throughput
hole. Connect the cables to the appropriate terminal on the
camera. Position the camera over the mounting holes and
use the included fitting screws to affix the camera to the
mounting surface.
Adjust Camera Positioning
Adjust the camera lens so that it can monitor the desired area.
Confirm all connections are secure. Replace the dome cover
and twist to lock into position. It is recommended that silicon
is injected into the gap between the camera and mounting
surface for secure waterproofing.
1. CONTENTS
2
3
4
1
.
.
PAN
TILT
ROTATE
PAN
TILT
ROTATE
Note: Rotate the lens from the rear of the lens
gimbal where there are grip notches.