Concept Pro AIR701/IRH, Руководство пользователя, Страница: 5 / 14

CONNECTION
BNC CONNECTOR
RS485 CONNECTOR
POWER CONNECTOR

Connect the video out port to your video cable
running to the monitoring recorder.

Check the power supply is of the correct level
and connect your power supply into the power
port on the Camera.

View the picture on a monitoring device to
check the power and video connection is
working properly.

Connect the RS485 to keyboard (if required)

When using the VA- for RS485 control
please use the command ‘Preset 95’ for entering
the menu and again for entering sub-menus
PSU
DVR CAM MENU SET PRESET
AUX/
SEARCH
RUN/
PANIC
PATTERN/
SETUP
PREV /
DISPLAY
NEXT /
SEQ
MON
CAM/DVR
ESC
ENTER
1 2 3
4 5 6
7 8 9
0
OPEN FAR WIDE
IRIS FOCUS ZOOM
CLOSE NEAR TELE
POWER Rx Tx
*
DVR AI CAM
ALM/ GROUP/ OFF/ ON/ VST/
Troubleshooting
 Ensure all power and cable connections are correct with the Camera, DVR and Test monitor
or Telemetry devices if used.

Power Voltage Check - Remove the OSD cover to see if the green correct power LED is lit. If
there red LED is lit the power voltage is too high. If the yellow LED is lit the power voltage is
not high enough. If there are no LEDs lit there is no power getting to the camera
 If all power and cable connections are correct and the camera picture can not be produced or
configured then contact your supplier for technical support.
All manuals and user guides at all-guides.com