RocketLinx WR7802-XT Series User Guide
: 2000638 Rev. A
Switch Configuration | Port Statistics Page - 69
Configuration Using the Web User Interface
Switch Configuration | Port Statistics Page
You can use this page to view the port statistics. The statistics that can be viewed include Link State, Rx
Good, Rx Bad, Rx Abort, Tx Good, Tx Bad and Collision. Rx means the received packet while Tx means the
transmitted packets.
Note:
If you see many Bad, Abort or Collision counts increased, that may mean your network cable is not
properly connected, the network performance of the port is poor, and so forth. Check your network cable,
Network Interface Card of the connected device, the network application, or reallocate the network
traffic.
Port Statistics
Port
This is the port identifier.
Link
Indicates the link status, Up or Down.
RX Good
The count of good frames received, which is the total number of received
unicast, broadcast, multicast, and pause frames.
RX Bad
The count of bad frames received, which is the total number of undersize,
fragment, oversize, jabber, RXErr, and FCSErr frames.
RX Abort
The count of aborted frames received, which is the total number of
discarded and filtered frames.
TX Good
The count of good frames transmitted, which is the total number of
transmitted unicast, broadcast, multicast, and pause frames.
TX Bad
The count of FCSErr frames transmitted.
Collision
The count of collision frames. Collision is the collisions frames (including:
single, multiple, excessive, and late collisions frames).
Select
Click
Select
on a row (port) and you can click
Clear Selected
to delete the
selected entry or entries.
Clears All
Click this button to clear all information from the table.
Refresh
Reload to refresh the counts.
Beta
Version
