Comtrol interchange vs1000, Руководство по установке и настройке

Страница: 15 / 46

Creating an AIOVS1 Load Line 15
Novell NetWare
Creating an AIOVS1 Load Line
The following procedure describes the basic load line used to load and
configure the VS1000 driver. For more information about load lines,
see the Novell documentation.
1. At the server console, enter the command to load the driver
manually. The syntax is as follows:
load AIOVS1 mac={MACADDR} node={NNN} nports=PP {trace}
name={SSS}
The parameters for the load statement are:
Note: If the load statement is entered with no parameters except the
MAC address, VS-Link assumes the protocol stack is being
configured.
Table 3. AIOVS1.NLM Parameters
Parameter Description
mac=MACADDR
This specifies the Ethernet MAC (Network
Address) of the VS1000. [REQUIRED]
node=NNNN
This optional parameter overrides the default
node number for this particular unit.
If a node number is not specified in the load
statement, the node number defaults to the
device count
(0 through 7), which is
incremented each time the load aiovs1
statement is executed.
nports=PP
This optional parameter lets you set the
number of ports on the VS1000 and
associated VS1100 expansion units.
For example, if you are loading VS-Link for a
single VS1000, set nports=16. If you are
loading VS-Link for a VS1000 with one
VS1100 expansion unit, set nports=32.
trace
This optional parameter causes VS-Link to
load with all tracing options enabled. For
more information, see the Troubleshooting
discussion later in this section.
Note: Enabling trace on load causes all
driver trace messages to be printed to the
system console.
name=SSS
This optional parameter sets the text name
for the VS1000. If omitted, the text name is
blank.