Comtech EF Data LBC-4000, Инструкция по установке и эксплуатации

Страница: 73 / 148

LBC-4000 L-Band Up/Down Converter System
Revision 6
Front Panel Operation 6–9 MN-LBC-4000
6.3.3.1.2 CONFIG CnvA or CnvB

ATTEN/SLOPE
LBC-4000/-ST: For CnvA :
CONFIG CnvA: Ofst=+0.0dB
Atten=00.00dB Slope=0.0
LBC-4000 only: For CnvB :
CONFIG CnvB:
Atten=00.00dB Slope=0.0
Typical for either, use the [

][

] arrow keys to select Atten or Slope .
Set the attenuation: Use the [

][

] arrow keys to select a digit to edit, and then use the [

][

]
arrow keys to change its value.
Set the slope value: Use the [

][

] arrow keys to select, in 0.1 increments, a value between
0.0 and 1.0.
For the CONFIG: Conv-A

ATTEN/SLOPE menu, the Ofst (Gain Offset)
command is available only if redundancy is enabled. See Appendix B.
REDUNDANCY OPERATION for further details on using this command in
redundancy applications.
Press [ENT] .
6.3.3.2 (CONFIG:) REMOTE (Remote Control) Submenu
Remote Control: Local
SERIAL ETHERNET
Use
the [

][

] arrow keys
to select Local , SERIAL , or ETHERNET . Press [ENT] .