Target interface
(H8S/2212F, H8S/2218F)
Mar. 03, 2008 (Second Edition)
■
H8S/2212F, H8S/2218F
Applicable products
*1
PALMiCE2-H8S
Applicable connectors
(Connectors for debugger)
MIL connector (14-pin design)
MIL connector
Signals
CPU Pin No.
CPU Pin No.
H8S/2212F H8S/2218F
H8S/2212F H8S/2218F,
Pin
No.
Signal
Input/
Output
*1
FP-64E
/64EV
TNP-64B
/64BV
TFP-100G
/100GV
BP-112
/112V
Pin
No.
Signal
Input/
Output
*1
FP-64E
/64EV
TNP-64B
/64BV
TFP-100G
/100GV
BP-112
/112V
1 TCK Input 53 53 84 D7 2 GND
3
TRST Input 55 55
86 A7 4 GND
5 TDO
Output
52 52 83 A8 6 GND
7
RESIN
*2
Input
8
VCC
*3
Output
9 TMS Input 54 54 85 C7
10
GND
11 TDI Input 56 56 87 B7
12
GND
13
RES Output 36
36
58 G8 14
GND
*1: Input/output is based on the target system.
*2: RESIN is not a name of CPU pin. RESIN signal cannot be directly connected to CPU pin. For connection, consult the target connection
reference diagram.
*3: For VCC, connect I/O power of CPU. Debugging can be performed even if the signal is N.C., however, if you connect I/O power, it will allow
prevention of leak during the target system power OFF and adaptation to power 1.8V-3.6V range.
Note, for input, it is 5V-tolerant. If optional conversion adapter (ADP-HUDI-5V) is used, 5V is supported for output.
Target connection reference diagram
MIL connector specifications
Recommended connector
Manufacturer Omron
Corporation
Model XG4C-1431
(Top view on the target board)
(For detailed dimensions of the connector,
refer to the documentation by manufacturer.)
*1: When debugging, bring EMLE pin to High state and FWE pin to High state
Shown in the target connection reference diagram is the circuit that brings EMLE pin to High state when you turn OFF the switch.
*2: RESIN, which is connected to Pin No.7 of the connector for debugger, is the signal that the debugger outputs to CPU. Connect the signal to
CPU by using user logic reset circuit with reference to the logic shown in the target connection reference diagram.
*3: RES, which is connected to Pin No. 13 of the connector for debugger, is the signal that debugger uses for monitoring the state of RES pin of
CPU.
