Computex FP-30, Руководство пользователя

Страница: 5 / 18

Technical Information on SPI Flash Programmer FP-30
Oct. 15, 2019 (Second Edition)
3
■
SPI interface signals
Signal table Target connection reference diagram
Pin No. Signal name Input/output *1
1 SRST *2 Input
2 VTref Output
3 SCK Input
4 GND -
5 CS1 Input
6 SI/SIO0 Bidirectional
7 SO/SIO1 Bidirectional
8 SIO2 *3 Bidirectional
9 SIO3 *3 Bidirectional
10
CS2
*3 Input
*1
:
Input/output are determined based on the hardware board
side.
*2
: The SRST signal is an open collector output.
When this signal is “LOW” on the hardware board, set each SPI
signal to high impedance state.
*3 : NC if the pins are not used on the flash memory.
■
Notes

Make sure to use the appropriate adapter for FP-30. Operation is only guaranteed if the appropriate adapter is
used.

The wire length between the ISP connector and SPI should be as short as possible. The shorter the better.

It is recommended to insert a damping resistor between the ISP connector and the SPI flash memory.