Computer Automation Technology CAT-800, Руководство пользователя

Страница: 58 / 105

7-1
Chapter 7 – Internet Setup
If you plan to connect the CAT-800 to your router it will not be necessary to make any changes to its
IP or GATEWAY addresses. If you intend to connect the CAT-800 to a different Internet source you
can use the Ethernet port or the USB port with the CAT-800 Editor program.
Internet Setup using Ethernet Port
With the computer set for DCHP addressing put the CAT- 800’s default address 192.168.1.245 in your
browser’s a ddress line. Refer to page 8-3 of this manual for the procedure to change the IP, ROUTER
and PORT settings as required.
CAT-800
ROUTER
ETHERNET PORT
Internet Setup using USB Port
Connect your computer’s USB port to the CAT -800 at J4 as described in the figure below.
NOTE: Do not use excessive force when plugging into J4. Lightly rock the plug from left to right until
you hear it snap into J4.
Start the windows editor program to display the
“CAT - 800 Repeater Controller Editor” main window.
Along the t op of the window click the “Load Default Settings” button. On t he main editor window click
the “Setup Internet/Input” button. Click on the “Internet Setup” tab. If you intend to connect the CAT-
800 to a different Internet source you can use this window to make changes to the new IP, Router and
Port addresses. See page 9-6 for instructions to change the IP, ROUTER and PORT addresses.
CAT-800
USB PORT