Installation Instructions
1. Select an area in your yard that is reasonably level and meets the
space requirements for your equipment. Ground Space: 9’ x 22’ Play
Space: 13’ x 37’.
2. Using the measurements from the top view diagram, measure and
mark the position of the Swing Hangers and Ladders on both 9’ Top
Rails. Place the Horizontal Ladder on the ground in the desired
location with Top Rails in the correct position on the ground.
(Measure and adjust the Horizontal Ladder on the ground as
necessary to provide for the proper play space.)
3. Move 9’ Top Rails and set aside.
4. With the Horizontal Ladder in its proper position, mark the locations
for the holes where the two Upright Ladders will stand.
5. Move the Horizontal Ladder and dig the holes (see #1 hole sizes for
cementing).
6. Lay each Upright Ladder on the ground near the hole where it will
eventually stand. On the non-drilled Upright Ladder make a mark 15”
from the top of the Ladder onto each Ladder rail.
7. Move the Adjustable Sleeves to these marks and position them to
receive the Horizontal Ladder. This is accomplished turning them to
point at a 90 degree angle toward what will become the inside of the
structure. (The rungs are welded to what will become the outside of
the structure.)
8. On the Upright Ladder with holes drilled in the Rails (the Slide will
attach to this Ladder), repeat the process similarly as on the other
Ladder. However, the Adjustable Sleeves will be pointing to, and the
rungs will be welded onto what will become the inside of the
structure. This will make it easier to climb up the Upright Ladder to
the slide. Secure set screws.
9. Place the Upright Ladders onto their sides with the bottom of the pipe
just over the hole where it will eventually stand. Attach the Horizontal
Ladder to the Adjustable Sleeves of the Upright Ladders and secure
the set screws (see #3 Horizontal Ladder to Upright Ladder