®
www.competitorswim.com
800-888-SWIM (7946)
®
©2013 Competitor Swim Products. All rights reserved.
BATTERY PACE CLOCKS
TROUBLESHOOTING BATTERY PACE CLOCKS
MODELS 200400 & 200405
Please review the following before calling customer service for assistance. You can also check our
website for information and dealer contacts for replacement parts.
REPLACEMENT PARTS CAN ONLY BE PURCHASED THROUGH A DEALER.
Clock Does Not Run
1.
Check to see if the battery needs to be replaced and if the battery is installed in the proper
direction.
2.
Remove the lens and check to see that the hands are on firmly. During movement over time, the
Minute Hand nut may work loose. Inspect the hands to make sure they are not bent or striking
each other when making a revolution.
3.
Remove the Second Hand by pulling lightly up away from the Clock Face. The Second Hand
works on friction. By lightly pinching the base of the Brass Hub you can increase the friction.
Once you have pinched the Hub, gently push it back on. Make sure that it is not bottomed out
as this will prevent the hand from turning.
4.
Remove the Copper Contact from between the AA Battery and the contact of the Battery Motor.
If the clock works with the Copper Contact removed, it indicates that the Switch needs to be
replaced.
5.
The Copper Contact assembly uses (2) copper plates mounted to a fiber board. If the copper
plates are damaged or the fiber board is missing, please contact your dealer for the replacement
part.
6.
If you isolate the problem to be within the Clock Motor, it is a sealed unit and must be replaced.
Contact your local dealer for replacement parts.
