P M 13 7 9
3-5 WIRE WELDING INSTALLATION.
1
2
7
4
6
5
3
1.- WIRE SPOOL / REEL.
2.- WELDING WIRE.
3.- GUN END.
4.- PRESSURE ADJUSTMENT KNOB.
5.- DRIVE ROLL.
6.- INLET WIRE GUIDE.
7.- GUN CONDUIT CABLE.
Try to keep straight gun
conduit when you going to install welding wire.
8
Wood
5
9
6
7
4
3
1
2
FUERA
INTERRUPTOR
DE LINEA
DENTRO
1.- PRESSURE GEAR ASSEM BLY.
Release pressure knob.
2.- PULL AND HOLD WIRE.
Cut off end.
3.- PUSH WIRE THROUGH GUIDES INTO
GUN
. Continue holding wire.
4.- CLOSE AND LATCH
pressure gear
assembly and let go wire. Install gun into
receptacle and tighten locking screw.
5.- REMOVE CONTACT TIP
and nozzle.
6.- PLACE SWITCH
in "ON" position.
7.- PRESS TRIGGER
until wire comes out
of MIG gun.
Reinstall contact tip and nozzle on MIG
gun.
8.- FEED WIRE TO CHECK DRIVE ROLLS
pressure, tighten knob enough to prevent
slipping.
9.-CUT OFF END OF WIRE.
Close and latch door.
Hold Wire Tightly to Keep It From Unraveling.
FIGURE 3-5. WIRE INSTALLATION.
3
POWER
5
