1-12
MSG/Removal and Replacement Procedures
1.6.6 Controller Board
1. Remove the four screws that secure the data cable
n
, then remove the cable.
2. Disconnect the three remaining cables
o
(spare part kit no. 170424-001) from the PCB.
3. Remove four screws
p
from the controller board.
4. Remove the four standoffs
q
.
Removing the screws and disconnecting the cables from the controller board
5. Remove the controller board
r
.
✎
When removing or replacing cables, disengage the cables from the cable clamp
s
.
To replace the controller board, reverse this procedure.