Removal and Replacement Procedures
NAS B2000 Maintenance and Service Guide
2-27
COMPAQ CONFIDENTIAL
Codename: Collins Part Number: 292280-001 Last Saved On: 5/30/02 11:58 AM
CD Ejector Assembly
To remove the CD ejector assembly:
1.
Power down the device. See the “Powering Down the Device” section in this chapter.
2.
Extend or remove the device from the rack. See the “Preparation Procedures” section in
this chapter.
3.
Remove the access panel. See the “Access Panel” section in this chapter.
4.
Remove the CD-ROM drive or CD blank. See the “CD-ROM Drive” section in this
chapter.
5.
Remove the diskette drive. See the “Diskette Drive” section in this chapter.
6.
Remove the CD MultiBay adapter board. See the “CD MultiBay Adapter Board” section
in this chapter.
7.
Use a Torx T-15 screwdriver to remove the ejector lever screw.
8.
Remove the ejector lever.
1
2
Figure 2-25: Removing the ejector lever
