Compaq Presario 5070, Руководство по техническому обслуживанию и ремонту

Страница: 83 / 113

Compaq.com - Compaq Presario Maintenance and Service Guide - 5200 Series
United States December 10, 2002
Maintenance and Service Guide
Compaq Presario 5000, 5100, and 5200 Series Computers
MSG index Product Description Troubleshooting Illustrated Parts Catalog
Home Removal & Replacement Jumper & Switch Information Specifications
Processor &
goalposts
Memory
module
Video
memory
Battery
System
board
Heat sink
clip
I-O panel
System
board
components
index page
l
REMOVAL & REPLACEMENT
System Board Components
Celeron II Processor & Goalposts
This page shows the removal and replacement procedure for a Celeron II processor.
Click the link to see how to remove an AMD K6-2 or Pentium II processor.
1 Perform preparation
procedures
2 Remove the hood
3 Remove the fax/modem
4 Open the system board
bracket
5 Locate the Celeron processor
CAUTION The processor
may still be
very hot if the
computer has
been running
recently.
6 Open the top lever of the
heat sink clip to release the
heat sink
7 Unplug the processor from
the system board and slide
out from the "goalposts"
To see how to remove the
goalposts , click this link.
If your goalposts are different from
those illustrated, you may need to
click on this link instead:
Alternative goalposts
To replace the Celeron II
processor, reverse the procedure
above.
IMPORTANT: Ensure that
the processor
is properly
aligned in the
goalposts
before
plugging it
into the
system board.
CAUTION: Before
installing a new
processor, see
Jumper and Switch
Information
to reset
the jumpers for the
processor. If the
processor is installed
with the incorrect
jumper settings, the
processor and
system board may be
damaged.
privacy statement
legal notices
http://h18000.www1.hp.com/athome/support/msgs/5000/c2remv.html [12/10/2002 9:34:01 AM]