Technical Reference Guide
Compaq Deskpro EXS and Workstation 300 Personal Computers
Featuring the Intel Pentium 4 Processor
First Edition - December 2000
4-15
4.4 SYSTEM
RESOURCES
This section describes the availability and basic control of major subsystems, otherwise known as
resource allocation or simply “system resources.” System resources are provided on a priority
basis through hardware interrupts and DMA requests and grants.
4.4.1 INTERRUPTS
The microprocessor uses two types of hardware interrupts; maskable and nonmaskable. A
maskable interrupt can be enabled or disabled within the microprocessor by the use of the STI and
CLI instructions. A nonmaskable interrupt cannot be masked off within the microprocessor,
although it may be inhibited by hardware or software means external to the microprocessor.
4.4.1.1 Maskable
Interrupts
The maskable interrupt is a hardware-generated signal used by peripheral functions within the
system to get the attention of the microprocessor. Peripheral functions produce a unique INTA-H
(PCI) or IRQ0-15 (ISA) signal that is routed to interrupt processing logic that asserts the interrupt
(INTR-) input to the microprocessor. The microprocessor halts execution to determine the source
of the interrupt and then services the peripheral as appropriate. Figure 4-9 shows the routing of
PCI and ISA interrupts. Most IRQs are routed through the I/O controller, which contains a
serializing function. A serialized interrupt stream is applied to the 82801 ICH.
Figure 4-9.
Maskable
Interrupt Processing, Block Diagram
The 82801 ICH2 component can be configured (through the Setup utility) to handle interrupts in
one of two modes of operation:
♦
8259 mode
♦
APIC mode
82801
ICH2
Interrupt
Processing
Serial IRQ
IRQ14,15
INTA-..D-
IRQ3..7,
9..12,
14,15
IDE
Hard Drives
INTR-
Microprocessor
I/O &
SM Functions
PCI Peripherals
I/O Controller
Interrupt
Serializer
APIC Bus
Содержание Deskpro EXS
Страница 2: ......
Страница 4: ......
Страница 6: ......
Страница 252: ...This page is intentionally blank...