Removal and Replacement Procedures
2-10
Compaq ProLiant BL20p Server Blade Maintenance and Service Guide
COMPAQ CONFIDENTIAL
Codename: AvalancheX Part Number: 316080-001 Last Saved On: 12/18/02 11:31 AM
Processor Power Module
To remove a PPM:
1. Power down the server blade and remove it from the server blade enclosure. Refer to the
“Server Blade Preparation” section in this chapter.
2. Remove the access panel. Refer to the “Access Panel” section in this chapter.
3. Open the latches on the sides of the PPM slot (1).
4. Remove the PPM from the slot (2).
1
1
2
Figure 2-7: Removing a PPM
Reverse steps 1 through 4 to replace the PPM.
