- 11 -
Using “AA” batteries to power the ICRI
FIGURE 4: BATTERY INSTALLATION (DRAWING)
Connect the adapter‘s plug to the jack labeled
DC INPUT
. Tighten locking screw, it is important
that the connector be firmly seated against the radio so that good electrical contact is made.
Note: Align the plug’s “key” with the jack’s “keyway” before attempting to insert the plug.
To release, loosen the locking screw and gently remove the connector.
Hold the battery housing securely in the palm of the hand with metal battery terminal plate facing up.
Push firmly on the center of the battery terminal plate, until the battery tray is released.
Remove old batteries and discard properly.
Replace the 8 "AA‖ alkaline batteries, observe the polarity markings within the tray.
To reinsert the tray, make sure the tray‘s key goes in the matching slot side of the case, Insert the tray
into the housing from the bottom end of the case, pushing the tray until it ―locks‖ into place.
Figure 5: "AA" BATTERY CONNECTED TO ICRI
The battery housing is comprised of two parts; the exterior case and an internal tray.
NO TOOLS ARE NEEDED TO REMOVE THE TRAY AND REPLACE THE BATTERIES.
