COMMUNICATIONS-APPLIED TECHNOLOGY ICRI-E, Инструкция по установке и эксплуатации

Страница: 13 / 30

- 13 -
Use an AC source to power the ICRI.
This power supply consists of two parts: the three-prong AC power cable and an AC to DC
converter with an interconnect cable.
Note: The AC supply must not be used where the cables or converter can become wet.
Connect the power cord to the converter and to the DC source (110-120V, 60Hz).
Connect the adapter’s plug to the jack labeled
DC INPUT . Tighten locking screw, it is important
that the connector be firmly seated against the radio so that good electrical contact is made.
Note: Align the plug’s “key” with the jack’s “keyway” before attempting to insert the plug.
To release, loosen the locking screw and gently remove the connector.
Note: DO NOT remove the power cable by pulling from the cable.
FIGURE 7: AC POWER ADAPTOR, CHECK +/-
FIGURE 8: AC POWER SUPPLY, VIEW 2