Guide:
SYSTIMAX
®
iPatch
®
Panel Manager Guide
2–12
3
Modify the power adapter for use with the local configuration for electrical
service outlets:
a
Select the appropriate AC plug.
b
Holding the power adapter in one hand, use your thumb to press the
spring-loaded latch on the back of the adapter to the open position.
c
Use your forefinger and thumb on your other hand to grasp the bottom
edge of the plastic protector. Then remove the plastic protector, exposing
the mating prongs. Release the spring-loaded latch.
d
Insert the tabbed edge of the AC plug into the top of the opening in the
power adapter. Then press on the plug until it snaps into place.
4
Plug the power adapter into an electrical service outlet.
Note:
A redundant power supply can be attached to the PWR2 jack on the back
of the Panel Manager (or the NET MGR PWR2 jack on the back of the Network
Manager module installed on the Panel Manager mounting bracket). When
using a redundant power supply, use the strain relief strap to secure both power
adapter cords to the display patch cord (or the patch cord connecting the
Network Manager module and the Panel Manager).
Figure 2–11 Modifying the Power Adapter
Press the latch to the open position.
Then remove the plastic protector.
Insert the edge of the plug into the adapter.
Then press on the plug until it snaps into place.
