4. Commissioning
Page 18
MF0123A1F
_FCC
_uc Manual for PSR 700/800 MHz
4.1.2. Property Damage Warnings for Mechanical Installation
1. Attention:
Do not install the unit in a way or at a place where the specifications
outlined in the Environmental and Safety Specifications leaflet of the supplier are
not met. Otherwise, the lifespan and performance of the repeater may be reduced.
2. Attention:
Due to power dissipation, the unit may reach a very high temperature.
Ensure sufficient airflow for ventilation.
3. Attention:
The repeater must be installed in a vertical position.
4. Notice:
Exceeding the specified load limits may cause the loss of warranty.
5. Notice:
Do not place cables or tools that may damage the repeater in close
proximity to it.
6. Notice:
Do not wear jewelry or metal accessories when installing this repeater.
7. Notice:
When connecting and mounting the cables (RF, optical, mains, ...) ensure
that no water can penetrate into the unit through these cables.
8. Notice:
Check all cables for shorts and opens. Verify that there are no cables with
loose or poor connections. RF leakage could cause oscillation to occur under
some conditions.
9. Notice:
If any different or additional mounting material is used, ensure that the
mounting remains as safe as the mounting designed by the manufacturer. The
specifications for stationary use of the Unit must not be exceeded. Ensure that the
static and dynamic strengths are adequate for the environmental conditions of the
site. The mounting itself must not vibrate, swing or move in any way that might
cause damage to the Unit.
10. Notice:
A spacing of 300 mm (11.81 inch) around the unit is required.
Specified torques must be observed for certain mounting procedures according to the
following table:
Type
Pins
Hex nuts
Screws
Thread
M6
M6
M6
Specified torques
3.3 Nm / 29.2 in lb
table 4-1 Specified torques
