CommScope PFU-P-E-O-060-01, Руководство пользователя

Страница: 17 / 27

1-Port 5Gb PoE Extender Manual
13
Step 4C: Connecting the Power Strands
1.
Cut the two power strands to length.
2.
For the 12 AWG cable, use a proper 12 AWG or 2MM diameter wire stripper. For the
16AWG, use a 16 AWG or 1.2mm wire diameter stripper.
Step 4D: Connecting the fiber
1.
After first disabling the extender input power, insert the SFP+ module (supplied separately)
into the SFP cage.
2.
Remove the sheath from the fiber tube such that the end of the remaining sheath will rest in
the fiber tray. Place the strippers at the desired strip location, close the wire strippers fully
once, then open. Now, by hand you may pull the center element jacket off, revealing the
aramid and optical fibers.
3.
Remove excess aramid as desired for termination.
4.
The fibers should wrap around the splice tray several times to allow for future re-splicing.
5.
If used, the splice to the fiber connectors should sit in the splice island in the splice tray.
6.
The fiber LC/UPC pigtails should wrap around the splice tray once, then connect to the
SFPs as below.
Note:
The wires maybe connected in either polarity.