Page 2 of 10
© 2019 CommScope, Inc. All Rights Reserved
3
Warnings and caution
3.1
Fiber optic cables may be damaged if bent or
curved to a radius that is less than the recommended
minimum bend radius. Always observe the recommended
bend radius limit when installing fiber optic cables and patch
cords.
3.2
Exposure to laser radiation can seriously damage
the retina of the eye. Do not look into the ends of any optical
fiber. Do not assume the laser power is turned off or that the
fiber is disconnected at the other end.
4
Kit content
The kit content is different for the splice and patch
application:
4�1
SPLICE APPLICATION
Splice: tray 1 and 2 are not connected when delivered (wrap-
around function).
4�2
PATCH APPLICATION
Patch: tray 1 (with patch panel) and tray 2 are connected
when delivered.
5
Closure preparation
5.1
Open the closure by lifting the latches using a
screw driver.
5.2
Install the 2 screws (3 turns) and the wedge (If
needed).
5.3
Slide the gel block on to the organizer (tray
1). Verify the correct orientation: Make sure the screw is
underneath the tray.
Tray 1
Tray 2
