6. When the connector end-face and adapter ferrule are clean, connect the drop cable to the optical port or reinstall
the optical port dust cap.
Note:
The optical port is not sealed until a drop cable connector or optical port dust cap is mated to the port
adapter.
6
Cleaning the HMFOC pinned/non-pinned connector
6.1
Cleaning the pinned HMFOC connector
1. Inspect the pinned HMFOC connector with a low-resolution microscope and inspect the complete ferrule surface
including the area around the pins for dirt or guide pin damage. If dust, dirt or contaminants are detected, proceed to
step 2.
2. The following are directions for cleaning an HMFOC pinned connector using US CONEC IBC brand cleaning tool - MT
Series.
Locate the red adapter on the cleaning tool and place it on the tip of the cleaning tool. Orientate the red adapter on
the cleaning tool so that the outside key slot is on the top. Locate the square notch on the threaded portion of the
pinned HMFOC connector. Hold the connector so the square notch is facing up.
Insert the cleaning tool into the pinned HMFOC until the cleaning tool is flush against the connector end face. Push
the cleaning tool forward into the HMFOC connector until a click is heard, then release the tool. Repeat this cleaning
motion as required.
Note:
Always follow the cleaning tool manufacturer’s cleaning instructions for best results.
page 5 / 9
© 2021 CommScope, Inc. All Rights Reserved