Figure 1
LightCrimp Plus LC simplex and duplex fiber optic
connector kits are designed to be applied to fiber
optic cable. The connectors are used with singlemode
or multimode 125– m glass fiber cable. These kits
can be used with any of the following media
(paragraph of assembly procedure is indicated
next to media).
Read these instructions thoroughly before assembling
the connector kit.
Reasons for reissue of this instruction sheet are
provided in Section 8, REVISION SUMMARY.
The simplex connector kit consists of a connector
assembly, short boot, and tubing. The tubing is used
with 250– m coated fiber. Also included, assembled
onto the connector, are a termination cover for the
ferrule (front of connector) and a protective cap for
the plunger (rear of connector). The duplex connector
kit consists of two of each of these components and a
duplex clip. The duplex clip is also available
separately.
— Micro–Strip Stripper 492109–2
— Combination Strip Tool 1278947–1
— Cable Holder Assembly 1754138–1 or
2064540–1 (only used to terminate connector with
termination cover installed)
Instruction Sheet
408-8925
LightCrimp Plus LC
Simplex and Duplex
Fiber Optic Connector Kits
Feb 2017 Rev E
®
©
2017 CommScope, Inc.
All Rights Reserved
This product is covered by one or more U.S.
patents or their foreign equivalents. For patents, see
www.commscope.com/ProductPatent/ProductPatent.aspx
To obtain information on CommScope products, visit our website at
®
http://www.commscope.com/SupportCenter
