CommScope ION-19P, Руководство пользователя

Страница: 16 / 43

3.1.2. Wall Mounting of RU

Check the suitability of the wall-mounting kit and the wall.

Mark the position of the drilling holes (for measurements and a more detailed
description refer to the wall mounting plan that is part of the delivery).

Drill four holes at the marked positions and insert dowels*.

Screw the mounting brackets to the wall / dowels using the four dowel screws as
illustrated in figure 3-1 Mounting bracket installation .

For each bracket, first screw in the 2 washers, then the 2 spring washers, then
the 2 M8x80 screws (see also figure 3-1 Mounting bracket installation ).

Hang the Remote Unit into the upper mounting bracket at a slight angle and let it
move smoothly towards the wall so that it engages firmly into the brackets (see
figure 3-2 RU wall mounting). Then, screw the Remote Unit to the lower mounting
bracket using 2 of the M8x25 screws that are part of the delivery (4 are provided).

Ensure that there is free access to the electrical connections as well as to the
cabinet. The approved bending radius of the connected cables must not be
exceeded.
figure 3-1 Mounting bracket installation figure 3-2 RU wall mounting
Upper
mounting
bracket
Page 16
Manual ION-M7P-7P-85P-19P
MF0145A4A.doc
* The dowels are not part of the delivery since the suitable type depends on the on-site conditions
(material of wall). Therefore, use dowels that are appropriate for the mounting surface.
M8 screws
Spring washer
Washer
Position of
dowels *
Lower
mounting
bracket