ADCP-90-451 • Rev C • October 2020
Page 2
© 2020, CommScope, Inc.
Admonishments
Important safety admonishments are used throughout this manual to warn of possible hazards to
persons or equipment. An admonishment identifies a possible hazard and then explains what
may happen if the hazard is not avoided. The admonishments — in the form of Dangers,
Warnings, and Cautions — must be followed at all times. These warnings are flagged by use of
the triangular alert icon (seen below), and are listed in descending order of severity of injury or
damage and likelihood of occurrence.
General Safety Precautions
1 PRODUCT DESCRIPTION
The 1RU Fiber Management Tray (FMT) is a rack-mount, front-access fiber optic tray available
in a variety configurations. Options listed are for reference only, for additional options contact
CommScope Technical Assistance at
http://www.commscope.come/SupportCenter.
Some of
these are noted below:
• 12- or 24-position termination and storage (left, right, or universal storage);
• 12- or 24-position termination and splice (left or right splice entry);
• 24-position termination with IFC;
• 24- or 32-position adapter only;
• 16-cable discrete slack storage;
• 32-, 48-, or 60-cable bulk slack storage (capacity dependent on cable diameter).
Rack-mount and recess options include:
• EIA or WECO, reversible 19- or 23-inch (48.26 or 58.42 cm) with mounting brackets for
mounting in 40mm or 5-inch recess;
Danger:
Danger is used to indicate the presence of a hazard that
will
cause severe personal
injury, death, or substantial property damage if the hazard is not avoided.
Warning:
Warning is used to indicate the presence of a hazard that
can
cause severe personal
injury, death, or substantial property damage if the hazard is not avoided.
Caution:
Caution is used to indicate the presence of a hazard that
will
or
can
cause minor
personal injury or property damage if the hazard is not avoided.
Danger:
Infrared radiation is invisible and can seriously damage the retina of the eye. Do not
look into the ends of any optical fiber. Do not look directly into the optical adapters of the adapter
packs. Exposure to invisible laser radiation may result. An optical power meter should be used to
verify active fibers. A protective cap or hood MUST be immediately placed over any radiating
adapter or optical fiber connector to avoid the potential of dangerous amounts of radiation
exposure. This practice also prevents dirt particles from entering the adapter or connector
.
