PMT200B SERIES DryLine
®
DEHYDRATOR USER MANUAL
12
3. Disconnect tubing from filter bowl assembly
input.
4. Remove screws from the bottom of chassis
holding the rubber isolators.
2. Disconnect compressor wiring from control
board.
(Board is shown pulled out for clarity)
Follow the instructions included in the
compressor overhaul kit. When the overhaul is
complete, reinstall.
RECOMMENDATION:
If the dehydrator overhaul process has taken
more than a few hours, it is recommended that
the unit be run for one hour into the room, to
purge the membrane dryer and tank of any
acquired moisture, before reconnecting to the
transmission line system..
