860463082
Instruction Sheet
www.commscope.com
Page 10 of 13
To install the splice trays in the RoloSplice:
1. Slide the splice tray over the rear latch and under the front latch in a RoloSplice pivoting tray. Orient the
splice tray so that the indentation is centered under the front latch.
2. Bend the pivoting tray slightly to allow the rear latch to engage the splice tray.
3. Push down on the splice tray at the rear latch until the splice tray snaps into position, fully engaging the rear
latch.
4. Install the pivoting tray in the RoloSplice base.
5. Dress the fibers as shown in Figure 11 and route the slack around the storage drums.
6. Connect the pigtail connectors to the adapters on the back of the faceplate.
Figure 11 Positioning the Splices and Fibers
Installing the splice tray in
the pivoting tray
RoloSplice base
Faceplate
Pigtail
