Commercial Electric 1007155949, Инструкция по использованию и уходу

Страница: 4 / 22

4
□ Insert the S-hook (GG) into the mounting hole located on
the back of the solar shop light (AA). Repeat this step on
the opposite end.
□
Mount the 18 in. hanging chain (FF) onto the screw
hook (HH). Mount the S-hook (GG) onto the hanging
chain (FF). Repeat this step on the opposite end.
2
Fastening the hanging chain to
the S-hook
HH HH
II II
FF
GG
HH
35 3/8 in.
1
a
Attaching two screw hooks to a
1
b
Attaching two screw hooks to a
wooden ceiling
ceiling ceiling
ceiling ceiling
Pre-Installation (continued)
Screw Hook and Chain Installation
□
Measure and mark the location. Drill pilot holes through
the wood using a 7/64 in. bit and cordless drill. Manually
tighten the screw hooks (HH) into the pilot holes.
AA
3
Hanging the shop light
□
Measure and mark the location for the self-drilling
drywall anchors (II). Drill pilot holes through the drywall
using a 3/16 in. bit and cordless drill. Drive the
self-drilling drywall anchors (II) into the pilot holes using
the drill. Manually tighten the screw hooks (HH) into the
self-drilling drywall anchors (II).
HH
HH
35 3/8 in.
ceiling ceiling
GG
AA
NOTE: The spacing between the screw
hooks (HH) should be 35 3/8 in.
NOTE: No anchors needed. The spacing
between the screw hooks (HH) should be
35 3/8 in.
□
The solar shop light is shipped with batteries preinstalled.
□
Select a location with full and direct sunlight. If installed in a shady area, the battery may not fully charge, resulting in the reduction of
working hours.
□ Before using the solar shop light, charge the batteries to full capacity after placing solar panel at a selected location. This initial charge
should be done with the shop light connected and in the OFF position. The batteries will reach full charge after two full days of sunlight.
□
Wipe the panel every few months to remove dust or debris that might affect the solar charge efficiency.
□
Before starting any installation, test the shop light for illumination.
- Push the POWER button on the shop light to turn ON light.
- The shop light should illuminate.
- If no light appears, cover the light sensor at the opposite end of the shop light to prevent light penetration.
- If the light does not illuminate, examine the battery compartment to ensure that the batteries are properly positioned. This can be
done by following battery replacement instructions on page 9.