G8-IAX / G3-IAX
Appendix
3.0/0616
39
Appendix
After dialling functions
On the VoIP phone, the following “after diallings” (similar to an Intercom station) are available:
Further connection (
0
)
Door opening (e.g.
1
)
Send re-call request (
5
)
Microphone mute (
7
)
Conference (
8
)
DTMF after-dial mode
After a conversation has been built up, the after-dial mode is switched automatically from DTMF dial-
ling to “Intercom dialling” (there is the possibility for after dialling in the Intercom system,
). Via a configuration via CCT 800, it is possible to deactivate the possibility for after
dialling in the Intercom system (the after-dial mode is switched fix to DTMF dialling).
Configuration CCT 800
Interfaces > IAX
For the respective channel, activate the checkbox
Fix DTMF After-Dial Mode
.
Send DTMF tone via ICX
During a call, it is possible to send DTMF tones via ICX messages.
ATTENTION: Outgoing phone calls by dialling channel manually
In order to be able to use the after dialling function on the VoIP phone in PABX mode, an appropriate
configuration via CCT 800 is required (
see ”After dialling at telephone – outgoing phone call” on
and
”Phone call by dialling channel manually” on page 30
ATTENTION: Automatic answer
No automatic answer from an Intercom station to a VoIP phone is possible (e.g. with
F
).
NOTES: Further information
At the Intercom station, after diallings can be made 8 seconds after the last digit of the respective call
number has been dialled.
For further information about the features listed above, see manual “
PRO 800 Basic
”.
NOTE: Activate DTMF dialling mode
By dialling
77
, it is possible to activate the DTMF dialling mode again.
Task
Type
Data
40
8A
TTTT 000x
NOTES: Variable “Data” in the ICX message
“TTTT” stands for the call number of the IAX subscriber.
“x” stands for the desired number, which shall be send as DTMF tone.
For further information, see manual “
ICX protocol
”.
