SIP station SIP-WS 201V CA
Connection diagram
appro
x. 1
.65
m
(5.4 ft)
Finished floor
160 (6.3)
140 (5.5)
275 (1
0.84)
255 (1
0.05)
4x
Ø
7
(0.28)
Camera illuminator control
The camera illuminator is connected via relay 2 (OUT 2) of the subscriber. It is also possible to use
relay 2 (OUT 2) as attendant contact, e.g. to switch on the camera illuminator at initiation of a call. The
dimming of the camera illuminator can be adjusted via the potentiometer
1
on the camera board.
NOTE:
The screw terminal and the connector of OUT 2 cannot be controlled separately (see connection
diagram).
Dimensions and recommended mounting height
Safety warnings
• This device shall be installed or replaced by trained and qualified personnel only.
• Do not install the device on unstable walls or on surfaces, which cannot support the device’s weight.
• Only use recommended tools when installing the device.
• Only accessories that comply with the device’s technical specifications shall be used.
• All connected circuits shall fulfil the requirements for Safety Extra Low Voltage (SELV) and Limited
Power Source (LPS) according to IEC/EN 60950-1.
• Use shielded Ethernet cables only.
• Before using the device, ensure all cables are correctly connected and not damaged.
• Disconnect the power supply (PoE or DC) for any maintenance of the device.
• Allow the device to cool down completely before touching parts inside.
• Do not make any unauthorised modifications to the device.
Cleaning instructions
The device may only be cleaned with cleaning agents for stainless steel. Do not use cleaning agents
containing chlorine or isopropanol.
Extent of supply
• SIP station
• Mounting screws (4 x Torx TR 25 security countersunk screws, M5x10)
• Short reference
Measuring units in mm (in), not to scale! Front panel thickness: 3 mm (0.12 in)
OUT 2
OUT 2
OUT 2
OUT 2
OUT 1
OUT 1
EP+
EP–
EM+
EM–
MUTE
GND
LINE–
LINE+
IN 1
IN 2
IN 3
GND
Expansion jack
Slot for inserting
button label
IP downlink
(Axis camera
+ PoE)
OUT 2 connection
IP uplink
+ PoE
LED brightness
+
–
Factory
Reset
button
External
loudspeaker module
Handset
(e.g. WSHS 50P-JST)
1
