Axis electronic module: control button
Axis camera module EM 6CA
Axis camera module EM 6CA for installation in the EE 8108M standard housing and EE 8999M basic
housing.
Attention:
It is not possible to install the module in the EE 8999S expansion housing!
Mounting instructions
Extent of supply
• Axis camera module EM 6CA
• Ethernet cable
• Connection cable
• Short reference
Connection
max.
1.5 Nm
!
5
3
1
NET
STAT
PWR
4
1
2
2
1
Control button
Follow the steps below to operate the control button:
1. Loosen the screw
1
(Torx T8).
2. Turn the safety lever
2
outwards.
3. Push the control button
3
.
4. Turn the safety lever
2
back into its original position and tighten the screw
1
.
Follow the steps below to reset the camera to the factory default settings using the control button:
1. Disconnect the power supply from the camera.
2. Press and hold the control button
3
and reconnect the power supply.
3. Keep the control button pressed until the LED indicator
4
flashes amber.
4. Release the control button. If the status LED
4
turns green, the process is complete.
Attention:
After a reset, the camera must be reconfigured, otherwise the camera image would appear 180° up-
side down.
Safety instructions
• This device shall be installed or replaced by trained and qualified personnel only (device class: ES2,
PS2 as per IEC/EN 62368-1).
• Only use recommended tools when installing the device.
• Use shielded Ethernet cables only.
• Before using the device, ensure all cables are correctly connected and not damaged.
• Disconnect the power supply (PoE) for any maintenance of the device.
• Allow the device to cool down completely before touching parts.
• Do not make any unauthorised modifications to the device.
