Example MP11x FXO Setup Guide v1.6
Last Updated: 6/11/18
P a g e
|
14
b. Wait = 30s
o
Intercom will advance to next phone number if it does not get a SIP 200
OK within 30 seconds of first call attempt
Audiocodes device programmed with:
o
Answer Supervision=yes (Search: ENABLEVOICEDETECTION)
o
VoiceMailInterface=DTMF (Search: VOICEMAILINTERFACE)
o
Disconnect Call Digit Pattern=2 (Search: TELDISCONNECTCODE)
Voicemail on phone re-recorded to start with DTMF 2 playing following by
standard voice greeting.
20. Caller ID
a. Caller ID from the SIP side comes from the SIP From header. For example:
From: “John” <SIP:[email protected]>;tag=35dfsgasd45dg
On the analog telephone side Caller ID is CNAME (name portion) and CNUM (phone
number).
b. Bellcore FSK is the type of Caller ID standard used in North America. This is the default
method set by the device (
“Standard Bellcore”).
c. On analog telephone POTS lines PSTN
telephone carriers will ignore
the CNAME and
CNUM in Caller ID; this is a fixed setting by the carrier. Therefore, you must connect to
the carrier by SIP or PRI ISDN to get custom Caller ID.
d. By default, Caller ID is disabled for the analog telephone side. Search:
ENABLE
CALLERID or use path above. Set “Enable Caller ID” to ‘Enabled’.
e.
Configuration
>
VoIP
>
GW and IP to IP
>
DTMF and Supplementary >
Supplementary Services (Radio Button must be set to Full at the top)
21. Registration
a. Registration of a device to the Audiocodes is optional. This could be helpful to keep track
of what stations are reachable in serverless setups.
