COMINOX Sterilclave 6 B Speedy, Руководство по обслуживанию

Страница: 47 / 64

47
Installation of the SPEEDY WATER demineralization system
To install the SPEEDY WATER demineralization system on a sterilizer already fitted with the
automatic water inlet 29 and the direct drain 30 , follow these steps:
• Install the support bracket A to a wall suitable to hold the weight of the plate and
of the purification block B during operations (5.6 kg). Take into account the vertical
space needed to position the block.
• Turn off the mains water tap and remove the plugs from the connections behind
the bracket.
• Connect the pipe from the water mains to the rear right section of the bracket
(bearing the label “IN” at the front) and the pipe to the sterilizer to the rear left
section of the bracket (bearing the label “OUT” on the front). Use the supplied
pipes (2 m each) and push them as far as possible into the connections.
• Remove the plugs positioned under the front cover of the bracket.
• Remove the protective plugs from the purification block B inlet and wet their
gaskets with demineralized water to ensure maximum efficiency.
• Lift the cover of the bracket and place the purification block B on the metal guide
pin C pushing it till the notch in the guide pin appears at the front.
• Fix the purification block B by fitting the metal blocking plate D into the groove in
the guide pin C and lower the cover of the support bracket A .
• Pull out the sterilizer (if built-in), place it in an appropriate position and remove the
cover.
• Replace the hose holders of the automatic water inlet 29 joint with the straight
fittings supplied and connect the pipe from support bracket A to the external one.
Speedy Water