COMINOX SterilClave 18 VLS, Руководство по эксплуатации и обслуживанию

Страница: 64 / 72

64
MAINTENANCE
GENERAL CONDITIONS
Maintenance must be performed when the unit is idle and unplugged from the power
source unless otherwise specified .
Avoid any temporary repairs; repairs must exclusively use original replacement parts.
The operator must provide prompt notice of any problem: dripping, wear, fraying, etc.
COMINOX declines all responsibility if the maintenance plan indicated in this manual is not
followed (see Maintenance Schedule table). Cominox also declines all responsibility if
maintenance is entrusted to untrained personnel or if the procedures suggested by our
installation technicians are not respected.
Cleaning
Clean the sterilization chamber 09 and the internal disk on the door 16 each day . Use a
cotton cloth soaked in alcohol or distilled water.
During cleaning, it is advisable to wear protective gloves.
If any scale is found, use stainless steel polishing products. Then remove any product
residue with a degreasing product and rinse thoroughly with distilled water.
Clean the workplace every day, checking that there are no clogs or blockages to
prevent proper ventilation of the sterilizer.
Maintenance
All maintenance must be performed by qualified and trained technical personnel
only.
!
Wait until the sterilizer has cooled completely and has NO heated surfaces. In any
case proceed with caution.
!
Always use personal means of protection.
!
DO NOT allow the unit to be used if a problem of any kind has been detected,
and arrange for proper restoration of normal operating conditions or make sure
that steps are taken in this regard.
!
For any defect or problem that cannot be resolved using this manual, contact a
COMINOX TECHNICAL SERVICE CENTER.
Please contact COMINOX for further details about the nearest TECHNICAL
SERVICE CENTER.
!
NEVER use chlorine-based detergents (bleach) which could lead to oxidation in
the sterilization chamber.
DO NOT use abrasive sponges or wools.
!