COMFORTPOOL FuzzyClean 7000, Руководство пользователя

Страница: 18 / 23

|
EN
18
5. Secure with a hose clamp.
NOTE: Be careful not to secure the return hose to the waste/backwash port.
3. Operation instructions
Once the filter system has been properly assembled, the tank filled with filter balls and the hoses connected as
described above, you may begin with filtration.
3.1. Filter system start up
Do not plug the system in until advised to do so below. Make certain the pump is not plugged into a power
supply.
Before operating the filter system, it is important to ensure that the filter system is positioned outside the pool
and is lower than the pool’s water level. The hose connections must also be correctly connected and fastened.
1. If you have not done so already, fill your pool with water. Ensure that the water level is at least 1"-2" (2.5
–
5 cm) above the top of the hose intake (skimmer) and return ports in the pool. The filter system is now
vented. If applicable, open the vent screw (pressure gauge) on the upper side of the filter cover until the
water flows out.
2. Release the shut off valve at the intake port (skimmer) in the pool. If you plugged the intake port
(skimmer), remove the plug to allow the water to flow into the intake hose. With the filter-pump system
installed in a location level lower than your pool’s water level - water will automatically flow into the filter
pump. Allow the filter tank to fill with water.
3. Check the filter system and the connection hoses for leaks and resolve, if necessary. Leakage points may
possibly arise due to manufacturing tolerances, which can be resolved by wrapping Teflon tape, available
at any plumbing or hardware store, around the connections before the connection hose is attached. Your
filter system is now ready for use.
3.2. Cleaning the filter balls
▪
Do not back wash on initial operation.
▪ No need to back wash unless tank’s pressure gauge reaches 25 psi.
▪
We recommend removing the filter balls from filter tank at the end of the season, place them in a mesh
bag, wash them in the washing machine (without detergent), let dry and return to tank for next season.
3.3. Important note regarding clarifiers
Pool water clarifiers or other chemical additives that bond to particulate matter for the purpose of improved
filtration must not be used if filter balls are the filtration media for your pool. Filter balls filter down to a small
particle size, 3 microns. Therefore, the addition of a clarifier will not improve the effectiveness of filter balls. The
clarifier or a similar chemical additive is likely to cause damage to the filter balls resulting in significant